ISX CM570 programming service

Cummins pre egr ISX / Signature 600 CM570 ECM fuel mileage and power programming and tuning - Not currently available

CM570 w/electric wastegate 586hp / 673bhp 1950 ft/lbs programming service

CM570 w/electric wastegate 660hp / 759bhp  2150 ft/lbs programming service

Estimated cost for this service:
Programming parameter changes - $50/hour
Reprogramming from $500  to  $1000
Estimated repair time: 24 hours

Here are a few common programming services DCS can provide for the CM570

- Speed limiter, cruise control and tire size and/or rear end corrections.

- Automatic to manual transmission swaps

- Engine fan engagement temperature changes.

- Inputs, Outputs, and multiplexing

- Customer password changes.

Diesel Control Service’s performance programming has been dynamometer tested on healthy engines. Provided your engine is healthy you will get similar results. The dynamometer graphs you see are horsepower and torque at the rear wheels. Wheel torque numbers are very high because the rear end ratio and tire size acts as a torque multiplier.

Fuel efficiency: Higher horsepower programs have the potential to be more fuel efficient due to lower parasitic losses relative to engine power output. This is what the automotive industry is doing right now to meet EPA fuel mileage and emissions standards. High performance engines with forced induction and reduced displacement are what this new eco technology is all about. If we can get a smaller engine to make the horsepower of a larger one then we are saving fuel, and lowering emissions. Black smoke is fuel that didn’t finish burning. White smoke is fuel that barely started burning. You won’t get white or black smoke from the work we do at DCS.  We have done our testing and none of the programming services we offer will trigger higher than stock emissions in a grams per horsepower-hour standard.