Series 60 DDEC IV programming service

1998 - 2002 Series 60 DDEC IV fuel mileage and horsepower programming and tuning Common applications: Series 60 12.7 MK BK PK TK, Series 60 14.0 HK HV

DDEC IV 430hp / 494bhp 1450 ft/lbs programming service

DDEC IV  580hp / 667bhp 1880 ft/lbs programming service

DDEC IV 600hp / 690bhp 1830 ft/lbs programming service

DDEC IV HK 700hp / 805bhp 1980 ft/lbs programming service

Estimated cost for this service:
Programming parameter changes - $50/hour
Reprogramming single stage: $800 All our Detroit programs are made to order so pick a horsepower, pick a maximum rpm, and pick a max torque from the table below.
Triple Play three stage programs w/install kit $1000: Pick three horsepower, rpm, and torque settings and we'll give you the switch
Stock throttle response or linear throttle response options with all programs
Common DDEC IV program options
Peak HP RPM 1 RPM 2 Torque option 1 Torque option 2
430 hp 1800 2100 1550 ft/lbs 1650 ft/lbs
500 hp 2100 2400 1650 ft/lbs 1850 ft/lbs
580 hp* 2100 2400 1850 ft/lbs 2050 ft/lbs*
650 hp* 2100 2400 1850 ft/lbs 2050 ft/lbs*
Estimated repair time: less than 1 day (we can ship it out the same day we get it) Please call to check our work backlog

Here are a few common programming services DCS can provide for DDEC IV ECMs for use on engine models PK, TK, MK, BK and the 14 liter pre-EGR HK

- Injector trim updates

- Speed limiter, cruise control and tire size and/or rear end corrections.

- Automatic to manual transmission swaps

- Engine fan engagement temperature changes.

- Re-configuring sensor calibrations to run with DDEC IV sensors or on an DDEC IV engine

- Inputs, outputs and multiplexing

DDECIVv2 copy.gif

The DDEC IV ECM is used on the 12.7 and 14.0 Series 60 as well as Series 50 applications. DCS can program your DDEC IV with a Three in one Triple pay program that features on the fly selectable program changes to horsepower, torque, injection timing, rpm limit, and engine response.

Diesel Control Service’s performance programming has been dynamometer tested on healthy engines. Provided your engine is healthy you will get similar results. The dynamometer graphs you see are horsepower and torque at the rear wheels. Wheel (raw) torque numbers are very high because the rear end ratio and tire size acts as a torque multiplier.

Fuel efficiency: Higher horsepower programs have the potential to be more fuel efficient due to lower parasitic losses relative to engine power output. This is what the automotive industry is doing right now to meet EPA fuel mileage and emissions standards. High performance engines with forced induction and reduced displacement are what this new eco technology is all about. If we can get a smaller engine to make the horsepower of a larger one then we are saving fuel, and lowering emissions. Black smoke is fuel that didn’t finish burning. White smoke is fuel that barely started burning. You won’t get white or black smoke from the work we do at DCS.  We have done our testing and none of the programming services we offer will trigger higher than stock emissions in a grams per horsepower-hour standard.